Hello,
I am configuring MDG for Materials freshly on ECC 6.0 following the instructions as mentioned in the SAP guide http://help.sap.com/erp_mdg_addon61/helpdata/en/5b/362c74ba324597ace35c6422370afe/content.htm
Except the Rule Based workflow, I got everything setup correctly, provide all authorization/roles, even able to create the change request to create new material and submit.
To configure the Rule Based Workflow, I went via tcode: USMD_SSW_RULE, Type of change request: MAT1. Under the DECISION TABLE - Single Value Decision Table - I entered the below 3 rows and when I activate it I get these messages:
Errors:
DT_SINGLE_VAL_MAT01 (Expression) : Result data object has a nested table, which is not supported (Detail)
DT_SINGLE_VAL_MAT01 (Expression) : Part of the result data object has the same ID like a condition column (Detail)
DT_SINGLE_VAL_MAT01 (Expression) : Part of the result data object has the same name like a condition column (Detail)
DT_SINGLE_VAL_MAT01 (Expression) : Columns must be adapted to change of result data object S_SINGLE_VALUE Display Related Object (Detail)
And below warnings:-
DT_SINGLE_VAL_MAT01 (Expression) : Next message refers to column New Chng. Req. Step (Detail)
NEW_STEP (Data Object) : Domain values may not be unique (see value table USMD202C_SSW in DDIC) (Detail)
DT_SINGLE_VAL_MAT01 (Expression) : Next message refers to column CR Previous Step (Detail)
PREVIOUS_STEP (Data Object) : Domain values may not be unique (see value table USMD202C_SSW in DDIC) (Detail)
CR_REASON (Data Object) : Domain values may not be unique (see value table USMD211C in DDIC) (Detail)
PARENT_STEP (Data Object) : Domain values may not be unique (see value table USMD202C_SSW in DDIC) (Detail)
I am not able to proceed from this and did as much research on Google to find any clue but no luck. Appreciate if someone could help.
(Error screenshot attached)
