This change request is not assigned to you

Hi all,

Good Day!!

This is the error I am getting. I understand no agent is found in my workflow, so the error pops up.

But I have configured all the possible steps to make it work...

Let me list down

Below is the issue:

Even though I have assigned the processor, it says, I am not the one…

Let me list down the steps I have done to make it work,,,

1. 1. Created CR with a Std WF..

1. 2. Uncheck the validation/auth checks

1. 3. Activate Linkage with BUS2250,Event CREATED.

1. 4. Marked the WF as General Task..

1. 5. Workflow steps assigned

1. 6. Workflow assigned with processor…

After all the above configuration has been done, I still get Processor error.. Am I missing out something

Please let me know.. Thanks