Hi All,
We have activated and configured MDGS with Vendor like UI by using configuration guide Configure Master Data Governance for Supplier (G43) from RDS. We will be using Co-deployment and thus did not have to configure for HUB. Our configuration were done in our master config client 201 and we had to transport our config to our 251 client were master data would be maintained and tested. MDG is working correctly in the 251 client and we are able to maintain Vendors in the MDGS.
Another department involved in the implementation wanted to Ale plant vendors using transaction BD14 to Ale the Plant vendors from client 201 where it was created to client 251. When they tried that, they got a short dump indicating that we have to configure DRF Customizing due to MDG that was activated.
I checked and all the ALE configurations were already setup correctly. We also configured all the DRF customizing, defined the settings for business systems and created the distribution model but still get the dump that DRF configuration is incomplete in our 201 client.
Error analysis
Short text of error message:
No DRF Customizing determined for client system D20CLNT201
Long text of error message:
Diagnosis
The IDoc processing could not determine DRF Customizing for the
client system D20CLNT201.
I also checked the replication model and the communication channel is setup with Replication with Idoc and Filter after change analysis.
We also tried transaction DRFOUT to see if we could determine if the config was incomplete. In simulation mode it picked up some vendors but when we removed the test selection it failed and indicated "Supplier could not be sent via vendor IDOC" with Diagnosis "The replication of the supplier via vendor IDOC is not supported by this implementation"
I have some questions:
1.Has anyone experienced the same problem and found a solution?
2.In the config step "Define technical settings for Business system" should the business system be the sending system and the logical system and
RFC destination be the receiving systems? I noticed that this setting affects the available value in Assign target systems for the Replication model.
3.Do we need to maintain any DRF customizing in our 251 receiving client
Your feedback would be highly appreciated.
Thanks and best regards
Riaan